Expansion Joints Replaced at Wastewater Plant
Existing joint material had become defective allowing leaking of fluid.
CASE
Stemming and Sealing High Voltage Transformer Oil Leak
Problem
Customer was looking for a solution to stem and seal oil leakages from flanges and under the high voltage bushing pockets.
Industry
Power Generation
Application Date
2023
Location
Ontario / Canada
Equipment Application
MPT-Mechanical Power Transmission
Subtrate
Other
Product
Belzona 1161 (Super UW-Metal)
Belzona 5831 (ST-Barrier)
Accessories
Repair Stages
Application Situation
Live oil leak from transformer in different parts required a solution with effective and quick turnaround.
Application Method
Surface was wiped clean using solvent / degreaser and then prepared according to SP11 standards. Surface was wiped clean and leak sealed using Belzona 1161 and 9341. Afterwards, two coats of Belzona 5831 was applied.
Belzona Facts
Customer was looking for a solution to stem and seal oil leakages from flanges and under the high voltage bushing pockets.
Contact your nearest Belzona Consultant and schedule a free evaluation!
Other Cases
Belzona Reclaims a Shaft After a Bearing Failure Damaged Both Ends
A hydraulic press on either end of an embossing roller is used to control appropriate operating pressure, caused premature bearing failure, damaging both ends of the shaft.
Repair And Coating for a Boiler Feed Pump
After 3 to 4 months in use the boiler feed pump was suffering from general corrosion/erosion and the metal shavings in the feed eventually would lead to a through hole in the casing.