With a wide range of case studies featuring different industries, equipment, products and more with hands on solutions provided.
During the refurbishment of an old piping system within a commercial building, the customer discovered an active leak at a lead and oakum joint. These joints, common in older plumbing systems, had degraded over time, compromising the seal and allowing water to escape.
Water tank was experiencing corrosion issues from many years of use.
Deterioration of the floor around the drainage area leads to potential safety hazards due to uneven surfaces and lack of slip resistance.
Customer had a tank and wanted to protect with a lining that would resist chemical attack, thereby extending its service life.
Two air handling units were heavily corroded and leaking in several areas. The whole basin needed to be coated and properly sealed.
An expansion joint in the parking lot ramp of a large residential building was defective, and the customer sought a permanent solution that would minimize disruption to the daily activities of the building’s residents.
Customer had a new pump and wanted to protect it before putting it in service to aid better longevity.
Fan was constantly going out of balance due to particulate sticking to the blade.
The customer was experiencing that their steel wheel conveyor system due to heavy loads were wearing grooves into the concrete floor.
The handrail of an escalator had 2 defective areas. The side of the rubber was ripped and presented a potential safety hazard for the mall customers.